Handcrafted In London: The Story Behind A Helmet Workshop

A helmet workshop in London works on a smaller scale than a mass production line, and that shapes almost everything about how a helmet gets made. Materials are chosen and checked by hand, shells are shaped and finished in small batches, and problems are caught by people who see every stage, not just a sensor on a line.

Getting helmet sizing right starts with a proper head measurement, taken with a soft tape around the largest part of the head, just above the eyebrows and ears. That figure points to a starting size, but it is only a starting point, since head shape varies as much as head size.

A made to order helmet starts long before any material is cut. Measurements are taken, the intended use of the helmet is discussed, and a rider works with the maker to settle on a shell, lining and finish that suit them specifically, rather than picking from fixed stock sizes.

A jacket built for riding, rather than a fashion jacket that merely looks the part, adds abrasion resistance across the shoulders and elbows, and many include pockets for armour inserts. Boots that cover the ankle protect a joint that takes real force in an off, Hedon Helmets and trousers or riding jeans extend that same protection down the leg.

An open face helmet leaves the face exposed, which some riders prefer for shorter journeys, city riding, or a more classic look on a café racer or scrambler. It offers less coverage than a full face design, and riders who choose one should weigh that trade off honestly rather than assume it based on style.

Once the shell is formed and cured, it moves through finishing: sanding, painting or leather trimming, and fitting the internal padding and retention system. Every stage is checked before the next begins, since a fault caught early is far cheaper to fix than one found at the end.